Parámetros de vuelo

Jump to: navigation, search
Other languages:
Deutsch • ‎English • ‎español




Tiempo de vuelo

The flight time module is used to store the current flight log entry. The time and departure/arrival places can be set manually or automatically. To let Air Navigation fill the time, departure and arrival places automatically, the "Automatic logbook" option must be turned on in Settings.

Flight edit.jpg

When the "Automatic logbook" option is active, almost all fields will be completed automatically during the flight, the fields can also be edited manually:

Aircraft
The Aircraft Identifier will be completed automatically with the ID of the currently selected.
Locations
Departure and Arrival will be set automatically with the nearest airfield.

Block and flight time

Block-Off
Block-off time is set when Air Navigation detects the movement of the aircraft.
Take-Off
Take-off time will be set when the speed passes 30 kts.
Landing
Landing time is set when the speed decreases to 25 kts.
Block-On
Block-on will be set when the aircraft stops. After 90 seconds with no movement, the flight will be stored in the logbook. This is to ensure that the block-on time will be registered in case you have to stop on the taxiway for example.

Landings

Multiple take-off landings will be added to the landings count. Our filters are designed to not record events in case the GPS signal is poor or invalid. Therefore you should check that the GPS signal is good (yellow or green symbol) before using the automatic logbook.

The logbook values can be edited at any time either from the «Flight time» module, by pressing on the corresponding line or, if the flight was already committed to the logbook, from the logbook module itself.

By pressing the «Edit» button in the top right corner, you can force commit the flight to the logbook or reset the «flight time» module to start a new flight.


If for any reason Air Navigation collapses and the application is closed during the flight, you can recover the session.

Note: on iPhone, if the «flight time» module is placed at the bottom tab bar (default), a red badge will start blinking with the time value as soon as the block-off time is set until the flight is committed to the logbook.


Aircraft

Choose your aircraft for the flight from the available ones in the "Documents" menu.


Alerts

Set alerts for different flight situations. To hide the message you can swipe it from right to left or tap it and press "OK".

Target altitude.jpg

When the option "Strong Alert" is turned on, the screen will blink and a sound will be played repeatedly until you hide it.

Cruise altitude alert

Cruise altitude alert.jpg

Set a target altitude and let Air Navigation Pro notify you when you reach it or leave it. You can fine tune this setting with the tolerance slider.

Ground proximity alert

Get alerted when flying below 500 ft. This alert won't be triggered in the vicinity of aerodromes.

Airspaces ahead alert

Be alerted prior to entering an airspace.

Airspaces
Select either the individual airspace classes, or choose to receive an alert for those airspaces that are displayed on the moving map according to your selection in Map Options - Airspaces.

Pilots in command

Select the current pilot in command. If you are logged into your Xample Services Account, your ID will be used.



Back to previous page.