El módulo EFIS exhibe el terreno en 3D durante el vuelo. Para utilizarlo, primero tendrá que descargar los datos 3D desde el Map Store. Estos datos son muy complejos y funcionan para el módulo EFIS y para el Gráfico de Elevación. Esto significa que, una vez que lo ha instalado en Air Navigation Pro, no será necesario instalar los datos de elevación.
Visualización
It will show a groundspeed indicator on the left and an altitude indicator on the right.
At the top of the screen, it will show the Heading indicator. On the lower left corner the elevation profile.
When pressing the retract button you'll be able to see the route and the moving map on the left side. To hide these, just press the expand button.
In the middle of the screen is the Attitude indicator. EFIS code engine has been programmed to work close to a real one.
At the bottom, there is a button that shows a different label depending on how and where you are flying.
Different modes and calibration
You might see the following:
Will be displayed when touching the Edit Mode button.
You can freely navigate throughout the terrain in this mode:
- Touching the screen and dragging up or down will change the pitch.
- Touching the screen and dragging left or will change the heading.
- Touching the altitude bar and dragging up or down will change the altitude.
- By touching on the left edge of the EFIS and dragging up or down you can move forward or backwards
Press it and a menu will open. You will be able to calibrate the attitude and the offset.
This will show when using an AHRS G mini gadget.
You will show when using Air Navigation Pro with X-Plane.
You will show it when using Air Navigation Pro with FSX.
Troubleshooting
- The attitude is freezed and there is a red button with the message "Attitude OFF".
- It's possible that the internal gyroscope is turned off or there is no connection to the external AHRS sensor. Make sure to activate them through "Tools - Sensors" under the sub-menu "Attitude Sources".
Back to previous page.