Difference between revisions of "Pair 2 devices/es"

Revision as of 18:20, 4 November 2015

Other languages:

English • ‎español • ‎français

La comunicación entre los dos dispositivos Apple se establece vía BLUETOOTH o Wi-Fi. El procedimiento para comenzar la conexión es el siguiente:

En el dispositivo principal (el que posee GPS):
- A nivel sistema, abrir Settings y seleccionar Wi-Fi y activarlo
- A nivel sistema, abrir Personal Hotspot, ingresar una contraseña a elección y activarlo. Cuando muestre que el Wi-Fi está apagado, seleccionar Bluetooth y USB solamente.
En el dispositivo secundario (el que no tiene GPS):
- A nivel sistema, abrir Settings, seleccionar Wi-Fi y desactivarlo.
- A nivel sistema, abrir Settings, seleccionar Bluetooth y activarlo.

On the slave device you should discover/see the master, Hotspot, device. Tap on it and select pair in the pop up Bluetooth pairing request. Immediately the pop up will also appear in the master device. Select pair in the pop up Bluetooth pairing request.

Bluetooth is now paired and ready to be used by Air Navigation Pro.
Start Air Navigation Pro on both devices. (Leave Wi-Fi off, it may interfere with the Bluetooth signal)

After doing this:

With the master device:
- Under "Configuration - Settings", switch ON Share GPS via Bluetooth.
- Under "Configuration" - "Sensors", make sure that iOS Location Services is ON and all other sensors are OFF.
With the slave device:
- Under "Configuration - Settings" make sure Share GPS via Bluetooth is OFF.
- Under "Tools" - "Sensors" make sure that iOS Location Services is OFF and all other sensors are OFF.
- Under "Configuration" - "Sensors", switch ON the Internal Sensors Bridge. The red light should change to orange and then to green. If not, toggle the switch.

Notes:

In order to maintain the connection Air Navigation Pro must be running on both devices at the same time during the whole flight.
Everything explained above also works using Wi-Fi instead of Bluetooth.
In some cases, cellular data (SIM card) should be ON for the paring to work.

Back to index

@@ Line 6: / Line 6: @@
 ** A nivel sistema, abrir Settings y seleccionar Wi-Fi y activarlo
 ** A nivel sistema, abrir Personal Hotspot, ingresar una contraseña a elección y activarlo. Cuando muestre que el Wi-Fi está apagado, seleccionar Bluetooth y USB solamente.
-* En el dispositivo esclavo (el que no tiene GPS):
+* En el dispositivo secundario (el que no tiene GPS):
 ** A nivel sistema, abrir Settings, seleccionar Wi-Fi y desactivarlo.
 ** A nivel sistema, abrir Settings, seleccionar Bluetooth y activarlo.